Reels of the Past and Some Still Here > PENN REELS

Old Penn Side Plate Broken in 2 Pieces REPAIR

(1/1)

nomdeplume57:
Here is a side plate I  and got er back together in a few days of ..cleaning, clamping,gluing,sanding,re-glueing, sanding,grinding,sanding,polishing, etc......
This is how it came to me


Cleaned with Brake Cleaner OUTDOORS wearing Gloves and paint mask (this stuff will kill your liver,pancreas,kidneys, lungs,Hell it is Bad Stuff) several times and let dry over night!!



Then glueing liberally with Super Glue sticking together holding in place while putting lid back on Glue then wiping excess with towell and clamping with makeshift clamp placing face down on a flat surface is important.
First run on it had to wight down the clap and vice grips I used to tighten Clamp....lol



Pre Sanding  Front




Pre sanding Back



More Glue to fill valley was needed in several steps to get repair  where it could be sanded and flush

Finishing off with severap hours of sanding filling and more sanding the buffing like Hell to get to this

odonj:
My Model 85 is broken in almost the same place.  Before I saw this post, I glued it with CA glue but without the extensive cleaning.  My concern is that if I actually try to use the reel it will fail in the same place.  I have some UV curing glue I may try if it does.

Wompus Cat:
That was a weak spot on those and many other reels of the day .That is why they started putting the Chrome rings and extra cross bars on reels to beef em up in those points.
If you get the Break CLEAN and use a good Super Glue like Gorilla Glue then it will be like a good Weld as it should break anywhere but in that spot !

Navigation

[0] Message Index